Arctic Cat ZR 6000 R CROSS COUNTRY, Operator'S Manual

Page: 91 / 108

87
2. Remove the lock nuts (and washers on the Sno
Cross model) securing the wear bar to the ski.
0743-185
3. Remove the wear bar from the ski.
Installing
1. Move the wear bar into position on the bottom of
the ski.
2. Align the wear bar studs with the holes in the ski;
then install the lock nuts with washers (Sno Cross
model only). Tighten to 15 ft-lb.
Rail Wear Strip
Arctic Cat recommends that the wear strips be checked
weekly and replaced as necessary. Measure the wear
strips at 25.4 cm (10 in.) intervals. Wear strips must be
10.7 mm (0.42 in.) thick or thicker. If wear strip mea-
surements are less than specified, replacement of both
wear strips is necessary to prevent premature track clip
wear and possible track damage.

NOTE: The rail wear strips will wear rapidly if the
snowmobile is operated on terrain on which the
snow cover is minimal. Loose snow is required to
cool and lubricate the wear strips and prevent
accelerated wear.
0744-875