Arctic Cat ZR 6000 R CROSS COUNTRY, Operator'S Manual

Page: 38 / 108

34
CWI-006A
9. Disconnect the coolant hose from the back of the cyl-
inder head.
10. Remove the cap screws with O-rings securing the
cylinder head (in the order shown); then separate the
head from the cylinders. Account for the O-rings on
top of the cylinders.
CWI-009
CWI-010
11. Remove the four nuts securing the fuel rail to the
back of the cylinders; then remove the fuel rail and
injectors as an assembly. Account for all gaskets.
CWI-011A
12. Remove the eight nuts securing the cylinders to the
crankcase; then using a soft hammer, gently tap the
cylinders and remove from the crankcase by lifting
them straight up off their studs. Account for a gasket
and alignment pins.
CWI-012
13. Remove the PTO-side piston-pin circlip from the
PTO-side piston; then remove the MAG-side piston-
pin circlip from the MAG-side piston.
CWI-013A
14. Using Piston Pin Puller and medium Extractor Nut,
remove the piston pins from both pistons.

NOTE: For proper assembly, keep all MAG-side
components and all PTO-side components sepa-
rated. Assemble them on their proper sides.
CAUTION
When removing a cylinder, be sure to support the piston
to prevent damage to the crankcase and piston.