Arctic Cat ZR 6000 R CROSS COUNTRY, Operator'S Manual

Page: 65 / 108

61
XM261
XM262
13. Install the ratchet block and tensioner; then set the
tensioner in the fifth notch in the block as it is self
tightening.
XM202
14. Install the chain case cover/oil tank assembly and
secure with the existing screws (threads coated with
blue Loctite #243). Tighten in a crisscross pattern to
12 ft-lb. Fill the chain case with 15 oz. of Arctic Cat
Chain Lube.
15. Connect the speed and oil sensor connector.
16. Install the right-side footrest support and secure to
the belly pan using the existing screws.
17. Install the resonator.
18. Secure the lower console to the skid panels; then
install the hood and both access panels.
Servicing Float X Evol Shock
Absorbers
Disassembling Shock Absorber

NOTE: Some illustrations and photographs used
in the following sub-sections are used for clarity
purposes and are not designed to depict actual
conditions.
1. Rotate both adjuster screws counterclockwise to
the full-open position.
2. Securely clamp the EVOL chamber eyelet (bot-
tom) of the shock in a soft-jawed vise; then
remove the green valve caps and set them aside.
A
3. Depressurize the main chamber first; then depres-
surize the EVOL chamber next.

NOTE: When depressurizing the chambers, a
“hissing” should be noticed as air is released.
Also, the shock normally contracts slightly due to
the internal negative spring.
4. Using a strap wrench at the very end of the sleeve,
loosen, but do not remove, the air sleeve.
! WARNING
Before starting, read through all of these instructions
first to become familiar with the procedure. Make
sure the work area is clean and all of the necessary
tools are available. These shocks contain high pres-
sure nitrogen gas. Always use proper safety equip-
ment such as latex gloves and safety glasses when
working on shock absorbers.