Arctic Cat ZR 6000 R CROSS COUNTRY, Operator'S Manual

Page: 89 / 108

85
FS373
24. Install the set screw (FAV3 valve assembly) and
tighten only until snug; then loosen two turns.
25. Insert the needle squarely into the center of the
nitrogen valve set screw and plug (taking care that
the valve is directed away from face and body) and
pressurize the reservoir to 250 psi.
FS374
26. Using a 3/16-in. hex key, tighten the set screw
(FAV3 valve) on the shock reservoir; then install a
new ball.
FS329
FS376
27. Install the bearings and retaining rings into the eyelets.

NOTE: Ensure proper shock function prior to
installing on the snowmobile.
Adjusting Rear Transfer Adjuster
Cams
The transfer system has seven positions. To make cam
adjustment, use the following procedure.
0741-231A
1. Loosen the Cap Screw (p/n 8020-040) and Lock
Nut (p/n 8047-366) securing the cams to the slide
rail. Remove the cap screw.
2. Using a 1/4-in. drive ratchet and extension, rotate
the cams to the desired position.

NOTE: Position 1 allows for the most weight trans-
fer, and position 7 allows for the least weight transfer.

NOTE: When setting the cams, the chosen posi-
tion must be directed toward the rear arm.

NOTE: Standard cam position is position 1.
3. Install the cap screw and lock nut to secure the
cam position; then tighten securely.
Lights
Removing Headlight Assembly
1. Remove the four screws securing the windshield to
the console; then remove the windshield.
2. Remove the four screws securing the windshield
brace to the console. Disconnect the gauge; then
remove the windshield brace assembly.
3. Disconnect the electrical accessory wires and igni-
tion switch.
! WARNING
Charge the shock using nitrogen gas only. DO NOT
CHARGE WITH ANY OTHER TYPE OF GAS. Doing so
will compromise the performance of the shock and
may be EXTREMELY DANGEROUS.