Arctic Cat ZR 6000 R CROSS COUNTRY, Operator'S Manual

Page: 35 / 108

31
4. Using Drive Clutch Bolt Tool, remove the torx-head
screw and high-collar washer securing the drive
clutch to the crankshaft.
5. Using Drive Clutch Puller and Drive Clutch Spanner
Wrench, tighten the puller. Remove the drive clutch.

NOTE: If the drive clutch will not release, sharply
strike the head of the puller. Repeat this step until the
clutch releases.
6. Remove the two screws (A) securing the heat shield
to the chassis; then remove the heat shield from the
two front locating pins (B) and remove the heat
shield.
EL-001A
7. Disconnect the ECM; then remove the screws secur-
ing the right- and left-side fascia panels to the chas-
sis. Remove the panels and ECM as an assembly.
EL-002A
8. Remove the cap screws securing the PTO-side front
spar to the steering support and shock mount bracket;
then remove the spar.

NOTE: Take care to not drop the spar inserts and
nuts when removing the spar.
9. Using a small needle-nose pliers, remove the servo-
motor cable holder; then pull the cable housings
down and out of the servomotor.
EL-004A
10. Slide each cable end out of the slot of the clutch; then
disconnect the harness from the servomotor.
11. Remove the cap screws and lock nuts securing the
shock mount bracket support to the shock mount
brackets; then remove the shock mount bracket sup-
port.
EL-003A
12. Remove idle speed control (ISC) hoses (A) from the
top of the throttle bodies; then disconnect the ISC
from the main harness (B). Remove the screws (C)
securing the ISC; then remove the ISC.
EL-006A
13. Loosen the four clamps securing the throttle body;
then lift up the throttle body and disconnect the cool-
ant hoses. Set the throttle body up and out of the way.
14. Remove the intake boot from the chassis.
15. Remove all three oil hoses from the front of the
engine.