Arctic Cat M 8000, Service Manual

Page: 80 / 210

79
CWI-058
4. Visually inspect the springs to make sure they are in
proper location on the seals.
CWI-083A
5. Inspect the water pump drive gear for any signs of
worn or chipped teeth. If either condition exists,
replace the gear.

NOTE: Lubricate bearings thoroughly prior to
assembly.
REMOVING/INSTALLING OUTER
CRANKSHAFT BEARINGS
 NOTE: The end bearings are not pressed onto the
crankshaft. The bearings can be removed simply by
sliding them off the crankshaft.
Inspect the crankshaft bearing area for wear. If any wear
is noted on either end, replace the crankshaft end.
 NOTE: Install the bearings by sliding each bearing
onto the crankshaft making sure the retaining pin
hole (A) in the outer race of the bearing is properly
positioned and will align with the retaining pin (B) in
the crankcase.
IO019B
REED VALVE ASSEMBLY
1. Carefully pry the reed assemblies from the intake
manifold and inspect the reed valves for cracks or
any deterioration; then remove the screws securing
the reeds.
CWI-084
2. To assemble, place the reed retaining plate (with the
lip facing outward) into position and secure with the
screws tightened to 10 in.-lb (± 2.2 in.-lb).

NOTE: When installing the outer reed valves, be
sure the clipped edge matches the clipped edge of the
reed retaining plate.
CWI-110
3. Install the reed valve assemblies into the intake man-
ifold by installing the top and bottom sides of the
reeds first; then press down making sure the reeds
are installed flush with the intake manifold.
CWI-055