Arctic Cat M 8000, Service Manual

Page: 167 / 210

166
CM086A
INSTALLING - ZR 4000 RR
1. Slide the alignment washers onto the end of the
driven shaft.
2. Install the key in the driven shaft keyway; then place
the stub shaft into the driven clutch. Place the driven
clutch on the shaft. Align its keyway with the driven
shaft keyway.

NOTE: A small amount of Loctite Anti-Seize
Thread Compound (p/n 0678-146) applied to the
driven shaft will aid in future driven clutch removal.
3. Secure the driven clutch by installing the washer and
cap screw (threads coated with blue Loctite #243).
Tighten the cap screw to 20 ft-lb.
REMOVING - 6000/8000
1. Remove the left-side access panel; then remove the
cap screw and washer securing the stationary sheave
to the driven shaft.
SNO-544
2. Slide the stationary sheave off the driven shaft and
account for the drive belt and offset shims.
SNO-547
3. Slide the movable sheave off the driven shaft.
DISASSEMBLING
1. Place the movable sheave on the Driven Clutch
Compressor Tool with the torque bracket facing up;
then install the compressor flange and handle against
the torque bracket.
2. Apply heat to the screws securing the torque bracket
to the movable sheave; then remove the screws.
XM342
3. Release the compression of the spring by removing
the wing nut; then remove the torque bracket, spider
assembly, and the driven clutch spring.
XM344
CAUTION
Do not allow the compressor tool to touch either of the
driven clutch bushings as it may cause damage.