Arctic Cat M 8000, Service Manual

Page: 122 / 210

121
FC117
ASSEMBLING/INSTALLING
FC111A
1. Slide the return spring over the end of the actuating
cable.
FC114

NOTE: Make sure that the small cable end spring
stays in place at the end of the cable.
2. With the cover gasket properly positioned, place the
valve stopper on the cable end and slide it down until
the cable end is inside the stopper.
FC113
3. With the valve plate gasket properly positioned, slide
the exhaust valve through the valve plate and insert it
into the valve stopper. Secure with the retaining
screw. Tighten to 48 in.-lb.
FC112
 NOTE: Note that the exhaust valve gaskets are
directional and must be installed correctly.
4. Slide the exhaust valve assembly into the cylinder.
XM017
5. Place the valve cover into position on the engine.
Secure with two cap screws. Tighten to 96 in.-lb.
KEY
A. Exhaust Valve
B. Cover Gasket
C. Valve Plate
D. Oil Seal
E. Gasket
F. Stopper
G. Stopper Pin
H. Return Spring
I. Valve Cover