Arctic Cat M 8000, Service Manual

Page: 164 / 210

163
REPLACING TORQUE BRACKET
BEARING/COVER BEARING
1. Remove the snap ring.
2. Using Movable Sheave Bearing Tool, drive the bear-
ing out.
3. Install the new bearing using Movable Sheave Bear-
ing Tool; then secure with a new snap ring.
REPLACING ROLLERS
1. Bend the locking tabs down away from the shoulder
bolt; then remove the bolt.
XM143
2. Place a new roller into position and secure with the
shoulder bolt (with a drop of red Loctite #271).
Tighten securely and bend the lock tabs to contact
the bolt head.
 NOTE: If the flat does not align with the tab, tighten
the shoulder bolt until it aligns.
XM144A
ASSEMBLING
1. Place the torque bracket onto the Driven Clutch
Compressor Tool; then install the spring seat (flat
side toward the spring) onto the torque bracket and
place the spring into position.
PC112

NOTE: Premature wear will result if the spring seat
is not installed.
2. Place the stationary sheave spring seat onto the
spring (flat side toward the spring); then noting the
alignment marks made during disassembling, place
the stationary sheave onto the torque bracket.
3. Place the movable sheave onto the stationary sheave.
4. With the clutch in place on the compressor, install
the compressor flange spacer and wing nut; then
compress the driven clutch spring.
XM139
5. With the driven clutch compressed, apply a small
amount of green Loctite #620 to the machined area
of the movable sheave so the Loctite can drip onto
the threads of the torque bracket.
XM142
6. Install new Screws securing the movable sheave.
Tighten in a crisscross pattern to 27 ft-lb.
! WARNING
Always wear safety glasses when using the bearing
driver.