Arctic Cat M 8000, Service Manual

Page: 75 / 210

74
CWI-005A

NOTE: For assembling purposes, note the indenta-
tion (A) of the stator plate is aligned with the harness
opening (B) in the crankcase.
CWI-005B

NOTE: The stator plate screws have Loctite applied
to the threads during assembly. Using an impact
driver, apply a sharp blow to the head of each screw
to break the Loctite loose before removal.
8. Remove the cap screws securing the APV assemblies
to the cylinders; then remove the APV assemblies
and set them aside. Account for all four dowel pins
and make sure the pins do not fall into the engine.
CWI-006A
9. Disconnect the coolant hose from the back of the cyl-
inder head.
10. Remove the cap screws with O-rings securing the
cylinder head (in the order shown); then separate the
head from the cylinders. Account for the O-rings on
top of the cylinders.
CWI-009
CWI-010
11. Remove the four nuts securing the fuel rail to the
back of the cylinders; then remove the fuel rail and
injectors as an assembly. Account for all gaskets.
CWI-011A
12. Remove the eight nuts securing the cylinders to the
crankcase; then using a soft hammer, gently tap the
cylinders and remove from the crankcase by lifting
them straight up off their studs. Account for a gasket
and alignment pins.
CAUTION
When removing a cylinder, be sure to support the piston
to prevent damage to the crankcase and piston.