Arctic Cat M 8000, Service Manual

Page: 178 / 210

177
YM-072A
4. Using a calipers, measure distances between the
sprockets and from the sprockets to each end of the
driveshaft for proper location (see appropriate illus-
tration).
0749-790
0747-960
5. Install the seal retaining plate; then install the exist-
ing snap ring.
XM283A
Track Tension
CHECKING
1. Remove excess ice and snow buildup from the track,
track drive sprockets, and the inside of the skid
frame.
2. Elevate the snowmobile on a shielded safety stand
high enough to use a spring scale.
3. At mid-point of the track (on the bottom side), hook
a spring scale around a track clip; then pull down on
the scale to the recommended pressure. Measure the
deflection (distance) between the bottom of the wear
strip and the inside surface of the track clip. Com-
pare the measurement with the chart in the General
Information section.

NOTE: Measurement is from the bottom of the
wear strip at the point of the shock pad on the slide
rail.
ADJUSTING

NOTE: To ensure proper track tension adjustment,
perform all adjustments on both sides of the snowmo-
bile.
1. Loosen the idler wheel axle cap screws.
0745-811
M 6000 153 ES/SP ES/LTD/LTD ES
M 8000 153 SP LTD/SP LTD ES
M 8000 162 SP LTD/SP LTD ES
XF CROSSTREK
ZR
M 6000 153 SP
M 8000 141/ES/SP/SP ES
M 8000 153/ES/HCR/SP/SP ES
M 8000 162 SP/SP ES
XF 8000 HC/HC SP LTD ES
! WARNING
DO NOT attempt to check or adjust track tension with
engine running. Turn ignition key to the OFF position.
Personal injury could result from contact with a rotating
track.