Arctic Cat M 8000, Service Manual

Page: 103 / 210

102

NOTE: At this point, pressure test the engine (see
the Engine-Related Items section).
38. With the raised edge of the valve aligned with the
channel of the cylinder, slide the APV assemblies
into position in the cylinders; then secure with cap
screws. Tighten to 96 in.-lb.
XM017
39. Secure the stator plate to the crankcase with the
Allen-head cap screws (coated with blue Loctite
#243) and tightened to 96 in.-lb.
40. Route the stator harness through the opening in the
crankcase; then secure the stator to the stator plate
with the Allen-head cap screws (coated with blue
Loctite #243). Tighten to 96 in.-lb.
CM143A
41. Secure the upper ignition timing sensor (white
dot/connector) with cap screws (coated with blue
Loctite #243). Tighten to 48 in.-lb; then install the
wiring grommet into the notch of the crankcase.
IO049A
42. Secure the lower ignition timing sensor with two cap
screws (A) (coated with blue Loctite #243). Tighten
to 48 in.-lb; then install the grommet. With the stator
harness properly positioned, install the plate and cap
screw (B) (coated with blue Loctite #243). Tighten to
48 in.-lb.
CM177A
43. Install the key in the crankshaft.
44. Place the starter clutch in position on the flywheel;
then secure the starter clutch with three cap screws
and tighten only until snug. While holding the starter
clutch, slide the flywheel onto the crankshaft making
sure the keyways match.
CM180

NOTE: Before installing the flywheel, be sure to
wipe the crankshaft and flywheel tapers clean using a
clean, lint-free towel.
45. Apply red Loctite #271 to the threads of the flywheel
cap screw; then finger-tighten with a large flat
washer. DO NOT TIGHTEN AT THIS TIME.
FC080