9-4
CD476
KM801C
5. Fill the master cylinder reservoir with DOT 4
brake fluid and bleed the system (see Section 2).
Throttle Control
REMOVING
1. Remove the boot from the throttle cable adjuster;
then loosen the jam nut and turn the adjuster com-
pletely in to loosen the cable.
2. Remove the three machine screws securing the
cover to the throttle control; then remove the cover
and disengage the throttle cable from the throttle
arm.
3. Turn the cable adjuster out of the throttle control
housing; then remove the two machine screws
securing the throttle control to the handlebar and
remove the throttle control.
INSTALLING
1. Making sure the throttle housing upper flat aligns
with the alignment mark on the handlebar, place
the throttle control into position on the handlebar
and secure with the two machine screws; then
tighten the machine screws securely.
KM122B
2. Thread the throttle cable into the throttle housing
and turn the adjuster completely in; then connect
the throttle cable to the throttle arm.
3. Install the throttle housing cover; then adjust the
throttle cable (see Section 4).
Back to TOC
Back to Section TOC
Back
Summary of Contents for ATV 250 Utility 2009
Page 1: ......
