3-6
250 Utility
1. Remove the seat; then remove the battery box
cover.
KM133A
2. Remove the negative cable from the battery; then
remove the positive cable.
3. Drain the coolant, engine oil, and transmission
gear lubricant; then install the drain plugs and
tighten to 21 ft-lb.
KM314A
KM314B
KM106A
4. Remove the gas tank cover panel and gas tank vent
hose.
5. Remove the side panels; then remove the front
rack and front fenders (see Section 8).
6. Remove the air filter housing (see Section 4).
7. Remove the gas tank (see Section 4).
8. Remove the muffler assembly (see Section 8).
9. Remove the carburetor (see Section 4).
10. Remove the coil (see Section 5).
11. Disconnect the stator connector, shift position con-
nector, trigger coil connector, and coolant temper-
ature sensor.
KM347A
KM324A
12. Remove the starter positive wire; then remove the
engine ground wire from the crankcase.
Back to TOC
Back to Section TOC
Next
Back
Summary of Contents for ATV 250 Utility 2009
Page 1: ......
