7-7
7
KM557A
9. Install the shock absorber and secure with the
existing hardware. Tighten to 29 ft-lb.
10. Install the axle housing, axle, and brake assembly
(see Section 6).
11. Install the drive chain and sprockets (see Section
6); then adjust the chain to specifications (see Sec-
tion 2).
12. Apply grease to the axle splines; then install the
hubs and hub nuts. Tighten to 72 ft-lb.
KM468
13. Install new cotter pins; then install the hub caps
and rear wheels. Tighten the lug nuts to 32 ft-lb.
KM469
KM464
14. Remove the ATV from the support stand.
Front A-Arms
NOTE: Critical torque specifications are located
in Section 1.
REMOVING
1. Secure the ATV on a support stand to elevate the
front wheels; then remove a front wheel.
2. Remove the hub cap; then remove the cotter pin
from the nut.
SP366
3. Remove the nut securing the hub.
4. Remove the cap screws securing the brake caliper;
then remove the caliper and lay aside.
! WARNING
Make sure the ATV is solidly supported on the support
stand to avoid injury.
Back to TOC
Back to Section TOC
Next
Back
Summary of Contents for ATV 250 Utility 2009
Page 1: ......
