3-17
3
2. Remove the ten cap screws securing the V-belt
cover; then remove the cover noting the location
of the two dowel pins. Note the condition of the
V-belt cover gasket. Replace if damaged.
KM253
3. On the 250 Utility using a suitable holder to pre-
vent the drive pulley from turning, remove the
drive face nut and starter ratchet; then remove the
drive pulley face.
KM365
4. Hold the centrifugal clutch with a suitable holder;
then remove the clutch retaining nut and clutch
collar.
KM364
5. Remove the outer clutch housing; then remove the
centrifugal clutch, driven pulley, and V-belt.
KM369
6. Remove the drive pulley collar and the movable
drive face taking care not to loose the rollers.
Servicing Left-Side
Components
RECOIL STARTER (250 Utility)
Removing/Disassembling
1. Remove the cap screws securing the recoil starter
assembly to the V-belt cover; then remove the
starter. Account for two alignment pins.
KM413A
2. Rotate the reel clockwise until the notch of the reel
is near the rope guide in the case. Guide the rope
into the notch and slowly allow the reel to unwind
until all spiral spring tension is released.
! WARNING
Always wear safety glasses when servicing the recoil
starter.
! WARNING
During the disassembling procedure, continuous
backward pressure must be exerted on the reel so it
does not accidentally unwind and cause injury.
! CAUTION
During the disassembling procedure, make sure all
spring tension is released before continuing.
Back to TOC
Back to Section TOC
Next
Back
Summary of Contents for ATV 250 Utility 2009
Page 1: ......
