6-7
6
KM508
11. Disengage the universal joint from the transmis-
sion output shaft splines and set the driveshaft
aside.
KM509
12. Remove the eight cap screws securing the swing
arm to the final drive gear case.
KM513
13. Support the swing arm from the right side; then
using a rubber mallet, drive the axle shaft from the
swing arm tube. Account for two O-rings.
KM536
KM537
14. Place the right end (shorter length) of the axle on a
wood block; then using a rubber mallet, drive the
gear case from the axle.
KM538
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all parts with parts-cleaning solvent and dry
with compressed air.
2. Inspect all seals for nicks, tears, or deterioration.
! CAUTION
Support the gear case by hand or damage to the gear
case could occur as it will fall free once it clears the
splined portion of the axle.
Back to TOC
Back to Section TOC
Next
Back
Summary of Contents for ATV 250 Utility 2009
Page 1: ......
