Anilam 6000M, Manual

Page: 67 / 149

CNC Setup Utility Manual
P/N 70000490C - Machine Constants
All rights reserved. Subject to change without notice.
10-December-04
2-57
Table 2-2, Machine Constants Setup (Continued)
Machine Constant
Parameter Function Settings
Handwheel Setup Parameters
MC_4100:
Handwheel Active The counter port is configured for
handwheel use. Off (not active) [Default]
On (active)
MC_4101:
Handwheel Resolution
Selects the axis resolution for the
handwheel attached to the port. Set
the resolution to MP Switch to select a
resolution from the jog selector on the
manual panel.
MP Switch [Default] – This setting
is available for Handwheel #1. The
resolution is determined by the
setting on the CNC’s Manual Panel
resolution selector rotary switch.
SK Switch – This setting is only
available for Handwheel #2. The
resolution is determined by a
setting selected via soft keys in
Manual Mode. See
P/N 70000487,
6000M CNC Programming and
Operations Manual
for more details.
Fixed 1 – Corresponds to resolution
x1, x10 and x100 respectively.
Fixed 10
Fixed 100
3-HW Adapter – Resolution
selected by a switch on a 3-
handwheel adapter.
MC_4102:
Handwheel Axis Selects the axis controlled by the
handwheel on this port. Set the axis to
MP
Switch to select an axis from the
rotary switch on the manual panel or
assign the handwheel to a dedicated
axis.
MP Switch [Default] – This setting
is only available for Handwheel #1.
The axis is determined by the
setting on the CNC’s Manual Panel
axis selector rotary switch.
SK Switch – This setting is only
available for Handwheel #2. The
axis is determined by a setting
selected via soft keys in Manual
Mode. See
P/N 70000487, 6000M
CNC Programming and Operations
Manual
for more details.
Fixed X – The handwheel axis can
be fixed to a specific primary axis.
Fixed Y
Fixed Z
3-HW Adapter– Axis selected by a
switch on a 3-handwheel adapter.
MC_4103:
Handwheel Scaling
Factor
Changes the sensitivity of the
handwheel. A higher number will make
the axis run faster. A lower number will
make the axis run slower. Range (0.0001–1.0000)
1.0000 [Default]