CNC Setup Utility Manual
P/N 70000490C - Machine Constants
2-4
All rights reserved. Subject to change without notice.
10-December-04
Table 2-2, Machine Constants Setup
(Continued)
Machine Constant
Parameter
Function Settings
MC_1013:
Disk access marker
Activates/deactivates the Disk access
marker.
On
- Activates the Disk access
marker. When the CNC is
reading/writing information
from/to a disk the Disk access
marker is displayed in the
upper-left corner of the
screen. The Disk access
marker looks like a small
arrow. [Default]
Off - Deactivates Disk access
marker.
MC_1014:
Max. memory
allocated
(in MB-bytes)
Used only with off-line software. Limits
the amount of memory available to the
software. This parameter is used to limit
the amount of memory available in
multitasking environments that provide
virtual memory.
Range (2–128)
4 (MB) [Default]
MC_1015:
Force simulation
mode
In Simulation Mode, the CNC does not
generate motor and I/O signals. The
CNC starts in Simulation Mode. Moves
can be commanded and displayed, but
no actual machine movements occur.
Yes
- Enable [Default]
No - Disable
MC_1016:
Screen blanking delay
(minutes
)
Specifies the screen blanking delay
period, in minutes. The delay will be the
time between a detected screen idle
condition and the activation of the
screen saver. To reactivate, press any
key.
Range (0–20160)
5 (minutes) [Default]
MC_1032:
Enable radius
compensation error
checking
Activates the tool radius compensation
error checking. The error checking is
designed to eliminate simple gouges
caused by overcompensation.
Yes - Enable
No
– Disable [Default]
(Continued…)
