Anilam 6000M, Manual

Page: 41 / 149

CNC Setup Utility Manual
P/N 70000490C - Machine Constants
All rights reserved. Subject to change without notice.
10-December-04
2-31
Table 2-2, Machine Constants Setup (Continued)
Machine Constant
Parameter Function Settings
MC_2239:
G33 Vel. Control
Integral Timecons
(.1ms) Velocity controller integral time constant
for G33. Range (0.000–100.000)
0.100 (0.1 ms) [Default]
MC_2240:
G33 Pos. Control
Prop. Gain (1/min)
Position controller proportional gain for
G33. Range (0.10–100.00)
40.00 (1/min) [Default]
MC_2241:
G33 Acceleration
FeedFwd. Gain
(.1mAs2/rev) Acceleration feed forward gain for G33. Range (0.0–1000.0)
0.0 (0.1mAs
2
/rev) [Default]
MC_2242:
G33 Colomb Friction
FeedFwd. Gain (mA)
Colomb friction feed forward gain for
G33. Range (-1000.00–10000.00)
0.00 (mA) [Default]
MC_2250:
Z Display Resolution Z-axis – See “ Setting the Display
Resolution .”
.5 Micron
1 Micron
2 Micron [Default]
5 Micron
10 Micron
MC_2251:
Z In-position
Tolerance Range Z-axis –See “ Setting In-Position
Tolerance ” to determine in-position
range.
Range (0.0000–9.0000)
0.0004 (inch) [Default]
MC_2252:
Z Default Feed Rate Setting the Z-axis Default Feed Rate
establishes a default feedrate for the
Z-axis, wherever a feedrate has not
been programmed. This applies to
programmed blocks or MDI commands.
Jog moves in feed (that is, from a
manual panel) can have a different
feedrate. Range (1.–50800.)
10. (inch/min) [Default]
MC_2253:
Z Default Rapid Rate Z-axis – See “ Setting Default Rapid
Rate .”
Range (1.–50800.)
500. (inch/min) [Default]
(Continued…)