Installation
9
NXP-TPI/4 NetLinx Touch Panel Interface
Installation
The NXP-TPI/4 is delivered from the factory with four installed input card covers (FIG. 4). The unit is
capable of supporting any combination of up to four TP4 input cards. The two different types of input
modules are the TP4-RGB and TP4-VID.
Upgrading the Memory and Compact Flash
The TPI/4 unit is shipped with two default modules (an EXM memory module and a Compact Flash
card).
Each module has a storage size of 64 MB
.
The Compact Flash card is factory programmed with specific TPI/4 firmware. These components can be
ordered from AMX in several different upgrade sizes (as listed in the following table):
Carefully remove the components from the shipping box. Refer to the Specifications table on page 2 for
more information on the unit and the available input cards.
FIG. 4
Factory default NXP-TPI/4
Input card covers
Grounding Bolt
Housing screws
Round screws
Flat-head screws
These components are on the internal circuit board.
ANY MEMORY UPGRADE
should be done after the removal of the factory installed card covers and
housing.
The best method of accessing the modules is to remove the outer TPI/4 housing,
replace the modules, then reinstall the housing. Refer to the Step 2: Removing the
Outer TPI/4 Housing
section on page 10
for more details.
Optional Module Upgrades
EXM Memory Module
Compact Flash
NXA-EXM128M - 128 MB memory card
NXA-CFTPI128M - 128 MB compact flash card
NXA-EXM256M - 256 MB memory card
NXA-CFTPI256M - 256 MB compact flash card
NXA-CFTPI512M - 512 MB compact flash card
NXA-CFTPI1G - 1 GB compact flash card
Summary of Contents for NetLinx NXP-TPI/4
Page 38: ...TPI 4 and Panel Interface Setup 32 NXP TPI 4 NetLinx Touch Panel Interface...
Page 60: ...Upgrading TPI 4 Firmware 54 NXP TPI 4 NetLinx Touch Panel Interface...
Page 138: ...Troubleshooting 132 NXP TPI 4 NetLinx Touch Panel Interface...
Page 147: ...Appendix 141 NXP TPI 4 NetLinx Touch Panel Interface...