Installation
12
NXP-TPI/4 NetLinx Touch Panel Interface
7.
While maintaining the 45° angle alignment on the new module, push it in firmly until the contact
pins are completely inside the connector.
8.
Push the card downward (to the main board) until the metallic braces snap around the memory
module and hold it in place.
9.
To complete the upgrade process, continue with the following step and/or re-install the outer
housing. Refer to the following sections for related procedures.
Step 4: Upgrading the internal Compact Flash card
1.
Discharge any static electricity from your body by touching a grounded metal object or the
grounding bolt shown in FIG. 4 on page 9.
2.
With the housing removed, locate the 64 MB Compact Flash card on the main board (for location
information, see FIG. 6 on page 11).
3.
Insert a grounded flat-head screwdriver into one of the card removal grooves (located on either side
of the card), and gently pry the card up and off the connector pins (FIG. 8). This alternating action
causes the card to "wiggle" away from the on-board connector pins.
4.
Slip your finger into the opening between the connector pins and the card, and push the card out to
remove it.
5.
Remove the upgrade card from its’ anti-static bag.
6.
Insert the upgrade card into the connector opening with the arrow facing towards the pins, then push
it in firmly until the contact pins are completely inside the Compact Flash card and securely
attached to the connector.
7.
Follow the procedures outlined in the following section to complete the upgrade process and
resecure the outer housing back onto the TPI/4.
Verify the new EXM memory module is correctly positioned using the alignment
groove located on the connector (as seen in FIG. 7 above).
FIG. 8
Removing the Compact Flash card
Under-side indention
located below
Insert with arrow
facing towards the pins
On-board Compact
Flash connector
Summary of Contents for NetLinx NXP-TPI/4
Page 38: ...TPI 4 and Panel Interface Setup 32 NXP TPI 4 NetLinx Touch Panel Interface...
Page 60: ...Upgrading TPI 4 Firmware 54 NXP TPI 4 NetLinx Touch Panel Interface...
Page 138: ...Troubleshooting 132 NXP TPI 4 NetLinx Touch Panel Interface...
Page 147: ...Appendix 141 NXP TPI 4 NetLinx Touch Panel Interface...