Programming
122
NXP-TPI/4 NetLinx Touch Panel Interface
Input Commands
These Send Commands are case insensitive.
Input Commands
^CAL
Put panel in
calibration mode.
Syntax:
"'^CAL'"
Example:
SEND COMMAND Panel,"'^CAL'"
Puts the panel in calibration mode.
^KPS
Set the
keyboard pass-
thru.
Syntax:
"'^KPS-<pass data>'"
Variable:
pass data
:
<blank/empty> = Disables the keyboard.
0 = Pass data to G4 application (default). This can be used with VPC or text areas.
1 - 4 = Pass data out to those respective cards.
5 = Sends out data to the Master.
Example:
SEND COMMAND Panel,"'^KPS-5'"
Sets the keyboard pass-thru to the Master. Option 5 sends keystrokes directly to the
Master via the Send Output String mechanism. This process sends a virtual keystroke
command (^VKS) to the Master.
Example 2:
SEND COMMAND Panel,"'^KPS-0'"
Disables the keyboard pass-thru to the Master.
The following point defines how the parameters within this command work:
• Accepts keystrokes from any of these sources: attached USB keyboard or Virtual
keyboard.
^MPS
Set the mouse
pass-thru.
Syntax:
"'^MPS-<pass data>'"
Variable:
pass data
:
<blank/empty> = Disables the mouse.
0 = Pass data to G4 application (default).
1 - 4 = Pass data out to those respective cards.
5 = Pass mouse buttons to the Master in the form of a custom event.
Example:
SEND COMMAND Panel,"'^MPS-1'"
Sets the mouse pass-thru to slot 1.
Note:
When this command is given, it causes all mice connected to the G4 product and
any mice on a computer connected via a card with USB output to reset to position 0,0.
Summary of Contents for NetLinx NXP-TPI/4
Page 38: ...TPI 4 and Panel Interface Setup 32 NXP TPI 4 NetLinx Touch Panel Interface...
Page 60: ...Upgrading TPI 4 Firmware 54 NXP TPI 4 NetLinx Touch Panel Interface...
Page 138: ...Troubleshooting 132 NXP TPI 4 NetLinx Touch Panel Interface...
Page 147: ...Appendix 141 NXP TPI 4 NetLinx Touch Panel Interface...