Configuring Communication
35
NXP-TPI/4 NetLinx Touch Panel Interface
Master Connection - Using ICSNet
Before beginning:
1.
Verify that an
ICSNet
cable is connected from both the rear of the TPI/4 to the NetLinx Master and
from the Master to an ICSNet port.
2.
Verify that the NetLinx Master is receiving power and is turned On.
3.
Connect the terminal end of the PSN power cable to the 12 VDC power connector on the rear of the
TPI/4 and supply power.
4.
After the TPI/4 powers-up, press the SETUP button on the front of the TPI/4 unit to continue with
the setup process and proceed to the Setup page.
5.
Press the
Protected Setup
>
System Connection
button (located on the lower-left) to open the
System Connection page (FIG. 23).
6.
Toggle the
ICSNET/Ethernet
field (
from the Master Connection section
) until the choice cycles to
ICSNet
. Refer to the
System Connection Page
section on page 75 for more information about the
fields on this page.
7.
Do not alter any of the fields in the IP Settings section (
using DHCP as the default
). These fields are
not user-editable and are used when connecting via ICSNet between the Master and the TPI/4.
8.
Press the
Protected Setup
button on the touch panel to return to the Protected Setup page.
9.
Press the on-screen
Reboot
button from the Protected Setup page to both save any changes and
restart the TPI/4.
This method depends on
first
connecting the ICSNet cable, having the TPI/4
recognize it, and
then
setting up ICSNet communication.
If the TPI/4 was not already powered, continue with steps 3 and 4. These steps allow
the TPI/4 to cycle through its available ports and detect any attached connectors.
FIG. 23
System Connection page (using ICSNet)
ALL
grey fields are read-only but still display the network information. Blue fields
toggle through available options. Red fields open the on-screen keyboard for
information editing.
Summary of Contents for NetLinx NXP-TPI/4
Page 38: ...TPI 4 and Panel Interface Setup 32 NXP TPI 4 NetLinx Touch Panel Interface...
Page 60: ...Upgrading TPI 4 Firmware 54 NXP TPI 4 NetLinx Touch Panel Interface...
Page 138: ...Troubleshooting 132 NXP TPI 4 NetLinx Touch Panel Interface...
Page 147: ...Appendix 141 NXP TPI 4 NetLinx Touch Panel Interface...