TPI/4 and Panel Interface Setup
29
NXP-TPI/4 NetLinx Touch Panel Interface
If your panel doesn’t match the initial TPI/4 output resolution, these manual setting
procedures must be done to "sync-up" both device settings.
3.
After choosing the desired resolution, use the monitor’s video controls to stretch and move the
incoming video so the borders of the desired resolution pattern follow the edges of the screen
without disappearing. There is normally 60 seconds before the resolution times-out, but you can
press the front panel RESOLUTION button again to return to the previous resolution pattern and
continue setting-up the monitor.
4.
Press and hold-down firmly the RESOLUTION button to save the resolution setting.
A message stating: "
Please wait, loading new resolution...
" appears to indicate the new resolution
being is saved. The Resolution Setup page then displays and exits the resolution setup process.
There is then some shifting of the defaulted Main page (which was developed for a 640 x 480
resolution).
5.
Press the front panel TOUCH button to proceed with setting the Touch Drivers (
next section
).
Step 2: Setting the Touch Drivers
After matching the resolution between the TPI/4 and panel/monitor, the next step is to select the
necessary touch drivers from the available series provide through the TPI/4.
1.
Press the TOUCH button on the front panel of the TPI/4 to set the touch driver and open the on-
screen Protected Setup page (FIG. 19). The default Touch Input Driver is
EloTouch
®
.
2.
Press the front panel TOUCH button to cycle through the series of available touch input drivers
(
firmware build 67 or higher
) shown in the following list:
Verify that the selected touch driver matches the connected touch panel or monitor.
Once your resolution is selected, you can use the outer screen area lines on the
Resolution Setup page to adjust your CRT monitor’s visible screen area. This could
involve using the monitor’s video control to stretch and move the incoming video so
that the borders follow the edges of the screen without disappearing. There are
normally 60 seconds before the resolution times-out, but you can press the front
panel Resolution button to continue.
Setting the touch drivers is mostly used when connected the TPI/4 to a touch panel.
If using a CRT, set the touch drivers to NullTouch
.
FIG. 19
Protected Setup page
Select
NullTouch
when using a CRT
or other non-touch monitor
Summary of Contents for NetLinx NXP-TPI/4
Page 38: ...TPI 4 and Panel Interface Setup 32 NXP TPI 4 NetLinx Touch Panel Interface...
Page 60: ...Upgrading TPI 4 Firmware 54 NXP TPI 4 NetLinx Touch Panel Interface...
Page 138: ...Troubleshooting 132 NXP TPI 4 NetLinx Touch Panel Interface...
Page 147: ...Appendix 141 NXP TPI 4 NetLinx Touch Panel Interface...