AMCI SV160E2, User Manual, Page: 19 / 120

20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786

Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
SV160E2 User Manual
SV160E2 S
PECIFICATIONS
19
Status LED’s
Each SV160E2 has three status LED’s. As shown in figure R1.4, these LED’s are located on the rear cover.
Drive Status LED
The Drive Status LED is a bi-color red/green LED. This LED shows the state of the unit as a whole.
Figure R1.4 Drive Status LED States and LED Locations
Module Status (MS) LED
The Module Status LED is a bi-color red/green LED. The state of the LED depends on the state of the net-
work adapter module.
Table R1.3 Module Status LED States
LED State EtherNet/IP Definition Modbus TCP Definition PROFINET Definition
Off No Power No Power No power
Alternating
Red/Green
Initializing: Power up Self-Test
Communications failure. There is a communications error between the main processor and
the ethernet co-processor within the unit. You must cycle power to the SV160E2 to attempt
to clear this fault.
Flashing
Green
Initializing: Waiting for valid physical connection to the
network.
Successful write to flash memory. Power must be cycled to the unit before additional

commands can be written to it.
Steady Green
Drive and Network are
operational. Drive and Network are
operational. Device Name or IP Address
are set.
Flashing Red
Initializing: IP Address conflict.
Initializing: Device Name or
IP Address are not set.
If the Network Status LED is also flashing, the IP Address or Network Protocol has been
changed. Cycle power to the unit to continue. If the Network Status LED is in any other
state, a write to flash memory has failed. Cycle power to the unit to clear this fault.
No Power
No Faults, Drive Enabled,
No Motion
Red Green Off
No Faults, Drive Enabled,
Motion Occurring
Drive Enabled, Command
Error or Input Error
Drive Disabled
Drive Disabled and
Command or Input Error
Configuration Error
or Encoder Fault
Unit Fault
1 Second 1 Second