IP 710 Manual
8
AltiGen IP Phone Service
AltiGen IP Phone Service is installed together with AltiWare and connects
to AltiWare through enhanced A protocol on behalf of IP 710
phones. This service must be running for the IP 710 to operate. If IP Phone
Service stops while the IP 710 is on a call, the call will be disconnected.
Plug and Play Feature
The IP 710 supports a plug and play feature when running AltiWare. When
the phone is first booted up, this feature enables the phone to automatically
discover the AltiServ IP address, instead of having to program the phone
manually. Refer to step 7 on page 16 for requirements and setup.
Note:
The plug and play feature requires AltiGateKeeper Discovery and
a single gatekeeper on the LAN.
Basic Mode
The IP 710 operates in Basic mode if it fails to register with AltiWare
during the startup mode. When in Basic mode, the IP phone’s LCD display
shows
(BASIC) IDLE
. No AltiWare switching features are available in
this operating mode. However, the phone user can enter a destination IP
address followed by
#
, and make an outgoing call through the IP network
to reach AltiWare or another IP 710 phone. Also, the IP phone can accept
incoming calls originating from AltiWare or another IP 710 phone.
Normal Operation
In normal operating mode, the IP 710 should have been registered with the
phone server and logged in as an extension. The time and extension appear
in the LCD screen and all phone features are enabled.
Note:
To make the IP 710 work in normal operating mode, open the
firewall port 10032 for the phone server. Refer to the
AltiWare OE/
ACC System Installation & Administration Manual
or
ACM
System Administration Manual
for information on other firewall
ports for H.323.
Summary of Contents for IP 710
