IP 710 Manual
22
To Remove the PoE Module
1. Remove the screw on the PoE Module cover, and remove the cover.
2. Notice the “feet” on the two tabs that are on the lower end of the
cover. Use these feet to lift the PoE module out of the compartment,
like this: Holding the upper end of the cover, slip the cover into either
the right side or left side of the module compartment, between the
compartment and the module, until the feet of the two tabs is under
the module (the inside of the cover should be facing toward the
module).
3. Pull up to remove the module.
Operation Notes
• When using #26 and #27 to log out/in, the IP 710 must be onhook.
Using the
Speaker
button to use #26 or #27 will not work.
• Two dial tones are always heard when going offhook on the IP 710.
• If two calls ring into the IP 710 at the same time and the user attempts
to answer the second call, the IP phone will automatically connect the
user to the first call.
• If the IP 710 is configured for a public IP address, you can call other
public IP address devices.
• If the IP 710 is configured for a private IP address, you can call other
private IP address devices that you can “see” or that are on your subnet.
• The daisy chaining of IP 710 phones is not supported.
• While the phone’s menu is being used, incoming calls will be directed
to the extension’s busy call handling setting.
Summary of Contents for IP 710
