Allied Telesis AT-S63, Features Manual

Page: 158 / 538

Chapter 14: Quality of Service
158 Section II: Advanced Operations
The QoS functionality described in this chapter sorts packets into various
flows, according to the QoS policy that applies to the port the traffic is
received on. The switch then allocates resources to direct this traffic
according to bandwidth or priority settings in the policy. A policy contains
traffic classes, flow groups, and classifiers. Therefore, to configure QoS,
you:
ˆ
Create classifiers to sort packets into traffic flows.
ˆ
Create flow groups and add classifiers to them. Flow groups are
groups of classifiers which group together similar traffic flows. You can
apply QoS prioritization to flow groups.
ˆ
Create traffic classes and add flow groups to them. Traffic classes are
groups of flow groups and are central to QoS. You can apply
bandwidth limits and QoS prioritization to traffic classes.
ˆ
Create policies and add traffic classes to them. Policies are groups of
traffic classes. A policy defines a complete QoS solution for a port or
group of ports.
ˆ
Associate policies with ports.
Note
The steps listed above are in a conceptually logical order, but the
switch cannot check a policy for errors until the policy is attached to
a port. To simplify error diagnosis, define your QoS configuration on
paper first, and then enter it into the management software starting
with classifiers.
Policies, traffic classes, and flow groups are created as individual entities.
When a traffic class is added to a policy, a logical link is created between
the two entities. Destroying the policy unlinks the traffic class, leaving the
traffic class in an unassigned state. Destroying a policy does not destroy
any of the underlying entities. Similarly, destroying a traffic class unlinks
flow groups, and destroying flow groups unlinks classifiers.