92
Rockwell Automation Publication ICSTT-RM448J-EN-P - April 2018
Chapter 5
Install the AADvance System
Fitting Termination Assemblies
Figure 16 - How to Fit Termination Assemblies
1. To fit termination assemblies do the following:
• Insert the
retaining clip
on the back of the termination assembly into
the
slot
on the I/O base unit. Press the
termination assembly
onto
the
base unit
and then slide the
assembly
upwards as far as it will go.
• Make sure the
retaining tab
clips over the
printed circuit board
to
secure the termination assembly in position.
