Rockwell Automation Publication ICSTT-RM448J-EN-P - April 2018
145
System Start-Up
Chapter 6
Configure the IP Address in
the Controller
When you assemble a new AADvance controller, or install a new 9100
processor base unit, you have to configure the IP Address stored in the
controller.
The procedure to configure the IP Address uses the AADvance Discover
utility. Changes occur immediately and you do not have to start the controller
again. To set the IP Address do the following:
1. Write down the controller's MAC address (the Controller ID) displayed
on a label on the processor base unit. Install at least one 9110 processor
module into the processor base unit.
2. Make sure the program enable key is inserted in the KEY connector on
the processor base unit.
3. Start the AADvance Discover tool from the Start menu:
•
Start
All Programs
AADvance
AADvance Discover
.
• The AADvance Discover utility scans the network for controllers,
and creates a list.
• It can also be launched from within the Workbench under the
View
menu.
4. Locate the
controller
in the list and make sure that the status of the
controller is Configurable.
