FS2 Frame Synchronizer/Converter v3.0 22 www.aja.com
Chapter 3 – Installation & Configuration
Installation Overview
The installation and set up of an FS2 is very simple. Plug both AC supply cords
into AC mains power (separate branch circuits for redundancy), connect the
LAN connector to a LAN, WAN or local computer with a web-browser, and then
connect source and destination video and audio equipment.
Hazard! High Voltage. This situation or condition can cause injury due to electric
shock.
Warning! Do not open the chassis. There are no user-serviceable parts inside.
Opening the chassis will void the warranty unless performed by an AJA service
center or licensed facility
Warning! Disconnect the external AC power supply line cord(s) from the mains
power before moving the unit.
Warning! Do not defeat the safety purpose of the polarized or grounding-
type plug. A polarized plug has two blades with one wider than the other. A
grounding type plug has two blades and a third grounding prong. The wide
blade or the third prong are provided for your safety. If the provided plug does
not fit into your outlet, consult an electrician for replacement of the obsolete
outlet.
Warning! Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the device.
Warning! Since the Mains plug is used as the disconnection for the device, it must
remain readily accessible and operable.
Warning! Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the device.
Warning! To meet safety regulations for leakage current, connect the FS2 dual
power supplies to separate branch circuits.