114
Agilent X-Series Signal Generators SCPI Command Reference
System Commands
IEEE 488.2 Common Commands
*PSC
Supported
All Models
*PSC ON|OFF|1|0
The Power–On Status Clear (PSC) command controls the automatic power–on clearing of the Service
Request Enable Register, the Standard Event Status Enable Register, and device–specific event enable
registers.
ON (1)
This choice enables the power–on clearing of the listed registers.
OFF (0)
This choice disables the clearing of the listed registers and they retain their status
when a power–on condition occurs.
Remarks
The setting enabled by this command is not affected by signal generator power–on,
preset, or
*RST
.
*PSC?
Supported
All Models
*PSC?
The Power–On Status Clear (PSC) query returns the flag setting as enabled by the
*PSC
command.
*RCL
Supported
All Models
*RCL <reg>,<seq>
The Recall (RCL) command recalls the state from the specified memory register <reg> of the specified
sequence <seq>.
*RST
Supported
All Models
*RST
The Reset (RST) command resets most signal generator functions to factory–defined conditions.
Remarks
Each command shows the *RST value if the setting is affected.
The settings enabled by this command is not affected by a signal generator
power–on, preset, or *RST.
*RST uses the factory preset state which is better for automated testing, for
example sweep mode is set to single.
For a comparison of the SCPI preset commands, refer to
Table 3- 1, “Preset SCPI
Commands Overview,” on page 178
.
Range
Registers: 0 to 99
Sequences: 0 to 9
Key Entry
RECALL Reg
Select Seq:
