Agilent Technologies 5975C TAD VL MSD, Troubleshooting And Maintenance Manual

Page: 90 / 276

90 5975 Series MSD Troubleshooting and Maintenance Manual
4
General Maintenance
To Remove the MSD Covers
Materials needed
•
Screwdriver, Torx T-15 (8710-1622)
If you need to remove one of the MSD covers, follow these procedures
(
Figure 4 ):
To remove the analyzer top cover
Remove the five screws and lift the cover off.
To remove the left side cover
1
Open the analyzer cover.
2
Disconnect the narrow ribbon cable from the back of the local control
panel.
3
Remove the three screws that hold the left side cover in place.
4
Pull the cover left slightly to disengage the two right side tabs and then pull
it straight forward.
To remove the analyzer window cover
1 Press down on the rounded area on the top of the window.
2 Lift the window forward and off the MSD.
N O T E
The color of the MSD cover will vary, depending upon the model type, but the installation
and removal procedures are the same for all models.



WA R N I N G
Do not remove any other covers. Dangerous voltages are present under other covers.