PassFinder AP2520 VoIP Router/Gateway Operation Manual
Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd.
-
37
-
3.2.2.
Interface Configuration Environment
In order to communicate in an Ethernet and WAN(LAN or Serial Port)
environment, an IP address must be configured for each port. For commands
related to port IP address connection, refer to interface related commands. For
the WAN(SERIAL) port, configuration for lower level protocols is required as well
as IP address.
The LAN 1(for WAN) ports for PassFinder AP2520 are supports Legacy LAN,
PPP(PPPoE) for ADSL connection. In order to connect to the network, the WAN
protocol must match the one used at the other equipment, including
configuration variables. Discussion with the administrator of the other
equipment is recommended.
The Interface configuration mode, allows traffic management of particular
packets per interface. For security related Access-List, DHCP information, refer
to the “Configurations for Security and Internet” section.
For packet management information, refer to the “Configurations for Routing”
section.
3.2.3.
Routing Configuration Environment
The PassFinder AP2520 Gateway supports Static, Default, RIP V1/V2 and OSPF
V2 routing protocols. The routing protocol is responsible for assignment of
packet route, and PassFinder AP2520 is supports multi-protocols simultaneously.
Therefore it is required to configure which protocol to use. Refer to “Routing
Configuration Environment” and “Interface Configuration Environment”.
