PassFinder AP2520 VoIP Router/Gateway Operation Manual
Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd.
-
254
-
5.7.3.11.
signal (E&M Voice Port Command)
To specify the type of signaling for a voice port, use the
signal
command in
voice-port configuration mode. To restore the default value for this command,
use the
no
form of this command.
E&M Voice Ports
signal
{
wink-start
|
immediate
|
delay-dial
}
no signal
5.7.3.11.1.
Syntax Description
Keyword / Argument
Description
Wink-start
Indicates that the calling side seizes the line by
going off-hook on its E-lead then waits for a short
off-hook "wink" indication on its M-lead from the
called side before sending address information as
DTMF digits. Used for E&M tie trunk interfaces. This is
the default setting for E&M voice ports.
Immediate
Indicates that the calling side seizes the line by
going off-hook on its E-lead and sends address
information as DTMF digits. Used for E&M tie trunk
interfaces.
delay-dial
Indicates that the calling side seizes the line by
going off-hook on its E-lead. After a timing interval,
the calling side looks at the supervision from the
called side. If the supervision is on-hook, the calling
side starts sending information as DTMF digits;
otherwise, the calling side waits until the called side
goes on-hook and then starts sending address
information. Used for E&M tie trunk interfaces.
5.7.3.11.2.
Default
wink-start
for E&M interfaces.
5.7.3.11.3.
Command Modes
Voice-port configuration
5.7.3.11.4.
Usage Guideline
This command (signal) applies to analog voice ports only.
