ADB Safegate RELIANCE Intelligent Lighting Platform III, User Manual

Page: 57 / 118

4.0 Operation
The operation section cover the operation characteristics of RELIANCE IL.
4.1 Commissioning Work
4.1.1 Commissioning List RELIANCE IL
When you change the systems configuration or parameters for commissioning, fill in the following list to document your
changes for further service purposes:
Commissioning protocol for series circuits equipped with RELIANCE IL
Commissioner name____________________
Commissioning date__________________
Airport ____________________
Station __________________
Power circuit____________________
Measuring the series circuit
Loop impedance__________ Ohm
Insulation impedance__________ kOhm
Power values for brightness level set up?
Transformer tapping point__________ V
Power in secondary circuit at a level of 100%______ A
Effective current match__________ %
Phase angle at a level of 100%__________ ms
RELIANCE IL settings
Automatic lamp failure test ON or OFF?
•
Cycle time__________ sec.
Cyclic segment command On or OFF?
•
Cycle time__________ sec.
Max. number of segments __________
Max. number of remotes__________
Remote – type 102 or 112 YES or NO?
Source of symmetric value (by default DSP) DSP or CU?
Capacity measurement
Measured value __________
Threshold set (half of measured value) __________
Parameters for the regulator
Symmetric corrective factor controlled at all levels?
Value saved for all levels?
CCR Operation with RELIANCE IL
Segments set up?
UM-5005, Rev. 004, 2020/08/06 45
Copyright
©
ADB SAFEGATE, All Rights Reserved