ADB Safegate RELIANCE Intelligent Lighting Platform III, User Manual

Page: 108 / 118

Note
If you select a setting with a current flow less than 6,6 A you will receive an error message. The error message "
too
less current flows
" is displayed. The SRU self test cannot be executed in this case. The self test button is not
active in CCR with SCROLL or CCR without SCROLL tabs.
Figure 74: Self-test results view
Tip
You can hit save screen shot in most self test windows to document error cases if you wish. You also have the
option reset view which can only be selected after finishing self-test. The reset view button deletes the test
results after test.
10. Select the CCR control tab and navigate to SRU self-test.
The buttons to start self- test, etc., are now active
11. Hit the start button in the sequence section on the right side of the screen to execute the test.
The timer in the sequence section is counting down for 40 seconds until test results are received. The message "
Self-
test will be executed
is displayed during test. The tested lamps are being switched off during test and switched on
again as test is finished. The test results are stored in lucDMC.
Note
A question mark sign is shown next to the lamp address number before and during test. When test is finished, the
question mark symbol is replaced by a green check mark — if the state of the lamp (actual value, i. e. ON or OFF)
equals the nominal value — or a red cross symbol — if the actual value does not equal the nominal value.
12. Shut down lucDMC when you finished the self-test or hit reset view to delete the current results in lucDMC and restart
test.
There are five states that are shown in the test life cycle:
Figure 75: Sequence view lamp test
RELIANCE Intelligent Lighting
Maintenance
96
Copyright
©
ADB SAFEGATE, All Rights Reserved