6-2
Adaptec Ultra320 SCSI Cards User’s Guide
Installing the Driver for Windows NT 4.0
To begin driver installation, see either
Installing Windows NT 4.0 on page 6-2
Windows NT 4.0 is Already Installed on page 6-3
.
Installing the Driver When Installing Windows NT 4.0
To install the
a320raid.sys
driver when you are installing
Windows NT 4.0:
Note:
During Windows NT 4.0 installation, if your system
configuration has multiple arrays and/or single drives,
Windows NT 4.0 limits the size of the system partition you
can create to 1 GB.
1
Start your system with the Windows NT 4.0 Boot disk in the
floppy disk drive or the Windows NT 4.0 Boot CD in the
CD-ROM drive.
Note:
If DOS is installed and you are trying to install
Windows NT 4.0, then it may also be necessary to edit the
config.sys
file to include command lines for your
CD-ROM drive. See the system documentation for more
information.
2
When the following message appears on-screen, press the F6
key.
Setup is inspecting your computer system’s hardware…
If you are installing from CD, skip to
. If you are installing
from floppy disk, continue to
3
For Windows NT 4.0 Boot disk installation only: When prompted,
insert disk #2 in your floppy disk drive. After a few moments
you will see a blue screen. Continue with
4
Press S to specify an additional device.
5
Press Enter to select Others; insert the Adaptec HostRAID
driver for Windows disk in your floppy disk drive and press
Enter
.
U320 UG.book Page 2 Tuesday, September 23, 2003 1:47 PM
