3-19
Configuring the Adaptec SCSI Card with SCSISelect
To use SCSISelect to format or verify a disk:
1
Start SCSISelect. See
Starting SCSISelect on page 3-3
.
SCSISelect detects all Adaptec SCSI cards and displays the
model number, channel letter, slot number, and PCI address for
each card and channel.
2
Select the SCSI card and channel that has the devices you want
to format or verify. The Options menu appears.
3
Select SCSI Disk Utilities. SCSISelect scans the SCSI bus and
displays a list of all the SCSI IDs and the devices assigned to
each ID.
4
From the list of SCSI devices, select the device you want to
format or verify.
5
If the device has multiple logical units, and multiple LUN
support is enabled for that device, a menu of LUNs appears.
Select the LUN of the unit you want to format or verify. A small
menu appears.
6
Select Verify Disk Media or Format Disk.
■
If you select Verify Disk Media, SCSISelect notifies you of
bad blocks and prompts you to reassign them. Select Yes to
reassign the bad blocks or No to leave them as is. You can
press Esc at any time to abort verification.
■
If you select Format Disk, a prompt appears, asking you to
confirm that you want to format the disk. Select Yes to start
formatting the disk, or No to cancel formatting.
U320 UG.book Page 19 Tuesday, September 23, 2003 1:47 PM
