5-2
Adaptec Ultra320 SCSI Cards User’s Guide
Installing the Device Driver for Windows
To begin driver installation, see either,
Fresh Installation of Windows on page 5-2
, or
When Windows 2000 or Windows Server 2003 is Already Installed on
page 5-3
Installing the Driver For a Fresh Installation of Windows
1
Create a Windows driver disk. See
for more information.
2
Start the system and then press Ctrl-A to enter the SCSISelect
utility. Use SCSISelect to create the array and logical drive to
which you will install Windows.
3
After the array is built, insert the Windows setup CD in the
CD-ROM drive and restart the system to begin the Windows
installation.
Note:
When using a CD-ROM drive to install
Windows 2000, Windows Server 2003, or Windows XP
from the bootable CD, make sure Bootable CD-ROM
support is enabled. This is done through the System BIOS
Setup Utility.
4
Press F6 when this message is displayed:
Press F6 if you need to install third-party SCSI or RAID drivers
5
Press S = Specify Additional Device.
6
Insert the Windows driver disk you created, when the setup
prompts you to insert the manufacturer supplied disk into drive
A
, and then continue.
7
The screen displays the adapter drivers supported on the disk.
Select Adaptec HostRAID U320 Driver for Windows 2000/
2003/ XP
.
8
Your system will restart once more to finish setting up
Windows.
U320 UG.book Page 2 Tuesday, September 23, 2003 1:47 PM
