F-7
Migrating from HostRAID to Adaptec Ultra320 SCSI
4
Select the array by scrolling to it and pressing Enter. This will
display the members of that array.
5
Press the
D
key to delete the selected array. When prompted to
confirm deletion of the array, select Yes.
6
At the Deleting Information window, select None and press
Enter
.
7
When prompted, select Yes to continue.
8
Repeat Steps 4 through 7 if there is another array. You will also
need to delete any spares.
9
Once all the arrays and spares have been deleted, press Esc to
go back to the SCSISelect menu.
10
Use the arrow keys to select Configure/View SCSI Controller
and press Enter.
11
From the Configuration menu, select HostRAID and press
Enter
.
12
From the HostRAID Pop-up menu, select Disabled.
13
Press Esc, save change, then exit.
If you are using a dual channel card, select Channel B and
repeat the steps to disable HostRAID support.
Completing the Adaptec Ultra320 SCSI Driver Installation
After you have installed the Adaptec Ultra320 SCSI driver and
disabled HostRAID support, you need to complete the installation
so that the Windows operating system can detect the new driver
hardware.
To complete your Adaptec Ultra320 SCSI driver installation, follow
these steps:
1
Restart Windows XP.
Windows XP will automatically discover the new hardware and
will prompt you for the Adaptec Ultra320 SCSI driver.
2
At the Welcome to the found new Hardware Wizard window,
select Install the software automatically (recommended), then
click Next.
U320 UG.book Page 7 Tuesday, September 23, 2003 1:47 PM
