E-3
Migrating From Adaptec Ultra320 SCSI to HostRAID
14
Click Next again. You may be prompted with this warning
message:
“The software you are about to install does not contain a Microsoft
Digital Signature...”
Ignore the warning and click Yes to continue.
15
When the driver is copied on the hard disk drive, click Finish.
16
Click Close on the driver Properties window.
17
You will be prompted to restart the computer. Select Yes.
The new HostRAID driver will be displayed under SCSI and
RAID controllers in the Device Manager.
Enabling HostRAID Support
After installing the HostRAID driver, you must enable HostRAID
support before you can use the RAID features. To enable
HostRAID for the boot channel, follow these steps:
1
Press Ctrl+A keys simultaneously when the Adaptec BIOS
appears.
2
Select the channel where your boot drive is connected, then
press Enter.
3
From the Options menu, select Configure/View SCSI
Controller Settings
and press Enter.
4
From the Configuration menu, select HostRAID and press
Enter
.
5
From the HostRAID Pop-up menu, select Enabled.
6
Press Esc, save change, then Exit.
U320 UG.book Page 3 Tuesday, September 23, 2003 1:47 PM
