E-7
Migrating From Adaptec Ultra320 SCSI to HostRAID
2
At the Welcome to the Found New Hardware Wizard window,
select Next.
3
Select Install the software automatically (Recommended), then
click Next.
4
You may be prompted with this warning message:
“The software you are installing for this hardware: Adaptec xxxxx
HostRAID driver has not passed Windows Logo testing...”
Ignore the warning and click Continue Anyway.
5
Insert the Adaptec Installation CD into the CD-ROM drive
when prompted, then click OK.
6
When the driver is copied on the hard disk drive, click Finish.
7
You will be prompted to restart the computer. Select Yes.
Note:
To migrate the nonboot channel from SCSI to HostRAID,
follow the instructions for migrating from a boot channel for
your other channel.
Migrating With Windows NT 4.0
Installing the HostRAID Driver
To migrate from SCSI to HostRAID with a Windows NT 4.0
operating system, follow these steps:
1
Start Windows NT 4.0.
2
Click on Start=>Settings=>Control Panel.
3
In the Control Panel, double-click the SCSI Adapters icon, then
click on the Drivers tab, then click Add.
4
From the Install Driver window, click Have Disk....
5
Insert the Adaptec Installation CD into the CD-ROM drive. If
the CD automatically opens a welcome screen, click the Exit
button to close it.
6
At the Install From Disk window, click the Browse button and
path
D:\drivers\windows\nt4
(where
D
: is the CD-ROM drive
letter). Click Open, then click OK.
U320 UG.book Page 7 Tuesday, September 23, 2003 1:47 PM
