AD Boivin 2002 Snow Hawk, Service Manual

Page: 62 / 173

ENGINE / CYLINDERS AND CYLINDER HEADS 7 - 12
Verify the evenness of the intake connectors.
When installing a cylinder and/or a cylinder head, use the
alignment tool or the exhaust manifold to verify the seal between
the intake manifold and the exhaust before tightening the nuts of
the cylinder head.
Place the spacer nuts as shown in the illustration.
Tighten the nuts of the cylinder head to 22 N-m (16 lbf - ft) in a
criss-cross sequence. Tighten each cylinder head individually.
Install the armature flange, the fan housing, then the air
deflector.
Install a gasket on each side of the deflector.
Alignment tool
(P/N 420 8761 71)
Or use the exhaust manifold
to align the cylinders
Spacer nuts
Spacer nuts