AD Boivin 2002 Snow Hawk, Service Manual

Page: 41 / 173

ENGINE REMOVAL 4- 4
1
1
Electrical connections
o
Disconnect the wiring harness from the magneto via the
four-wire connector coming from the MAG side of the
engine. (Connector No.1 at right)
Engine mounting bolts
o
Remove the four bolts (No.1) on each side of the engine
and then remove the engine (complete with the engine
mounting plate) from the chassis.
ENGINE INSTALLATION
To re-install the engine, proceed using the instructions above, in
the reverse order. However, pay particular attention to the
following points:
o
Ensure that all engine mount bolts are securely
tightened. (325 lbf-in, 27 lbf-ft)
o
After installation of the throttle cable, verify the
maximum opening of the carburetor slide.
o
Check the alignment of the clutches and the tension of
the drive belt.
t t
CAUTION
There is a red dot on the MAG side carburetor and one on
the engine housing to match. Be sure to pair the dot on
the carburetor with the dot on the housing when re-
installing them since the PTO and MAG side carburetors
each have a unique calibration.