AD Boivin 2002 Snow Hawk, Service Manual

Page: 146 / 173

ELECTRICAL SYSTEM 14 - 12
POWER OF THE STARTER COIL
1. Disconnect the connector of the RED wire close to the
area of the ignition module.
2. Plug in the wires of the ignition timing tester, then place
the switch and the dials in the following positions:
3. Start the motor and check the "indicator" light.
4. Push the "RESET" button and repeat step 3 twice more.
Results:
a) The "indicator" light comes on : The power
created by the starter coil corresponds to the
prescribed tolerances.
b) The "indicator" light does not come on: The
problem is a result of a defect in the starter coil
or a bad ground.
POWER OF THE MAGNETO
(Generator ignition coil)
1) Unplug the 2-wire connectors between the ignition
module and the bundle of wires from the magneto.
2) Plug in the wires of the tester, then place the switch and
the dial in the following positions:
Tester Wires Wires of the tester component Position of the tester switch Position of the tester dial
N (2)
White/Red wire of
P (1) Engine ground
45
Tester wires Wires of the tester component Position of the tester switch Position of the tester dial
N (1)
GREEN wire from the
bundle of magneto
wires
P (2)
WHITE Wire from the
bundle of magneto
wires
"LOW" 80