AD Boivin 2002 Snow Hawk, Service Manual

Page: 157 / 173

WIRE, CABLE AND HOSE ROUTING 17-2
2
1
2
8
3
8
4
8
1
8
Under the transversal shaft (No. 1) of the chassis, the wiring
separates into two segments, one going toward the front of the
vehicle and the other going toward the back
Using a tie wrap, secure the wiring that goes toward the front of
the vehicle in the cable attachment (No. 2).
2- Nylon cable attachment
u u
WARNING
It is important that the wires be installed exactly where
they are intended to avoid interference during operation.
(Refer to the photograph on the right)
The section of the wiring harness going toward the rear of the
vehicle must pass under the gas tank bracket.
1- Tie wrap
2- Adhesive nylon cable fastener
3- Safety fuse
4- Tail light connection
Using a tie wrap, secure the wiring in the adhesive nylon
fastener (No.2).
Position the fuse (No. 3) correctly in the connector holder.
Using a tie wrap, secure the wiring harness to the two holes.
(Refer to the photograph on the right - No. 1).