AD Boivin 2002 Snow Hawk, Service Manual, Page: 105 / 173

FRONT FORK AND SKI 11 – 13
λ
NOTICE:
Before adjusting the torque, make sure the special tool (T) is
well fitted into the socket at the end of the cartridge.
o
Re-install the rubber cap (M).
o
Install the spring stop washer (S).
o
Make sure the O-ring (OR) is still in place. If not, re-
install it and push it against the stroke stop (F) to secure
it.
o
Install the spring guide (G).
o
Install and screw the lock nut (C) up against the guide
until a slight resistance can be felt.
o
Hold the fork leg in a vertical position, fully compressed,
and fill it with fork fluid up to 50 mm (2 in) from the top of
the outer tube.
Recommended fluid: Cartridge fork fluid, S.A.E. 10W
o
Move the piston rod in and out, in a series of complete
alternating strokes, until a continual resistance can be
felt during a complete stroke.
λ
NOTICE:
It is possible that fluid will have to be added a few times before
reaching the point where a continuous resistance can be felt
during a complete stroke.
υ
WARNING
Keep a finger pressed against the opening of the piston
rod since the needle, if it has not been taken out, can be
ejected during this operation. If this happens, re-install
the needle after the operation has been completed.