Access 7000, Installation Manual

Page: 69 / 143

ASSEMBLY
Fig. 58 Shaft profile assembling on the architraves
Tip: Cut out a square from the first shaft profile above the door (20x20 mm) on one side, for better
fitting.
Tip: Try to make profile cuts in the end of the shaft profiles to avoid visible joints.
Note:
Make sure that the joints of the shaft profiles and the joints of the architraves
do not coincide to provide better stability of the shaft. Recommended disloca-
tion of the shaft profile joints and architrave joints is about 400 mm.
• Assemble the shaft profiles so that the pre-drilled holes are situated towards the centre of the shaft.
• Fasten the shaft profiles by screwing installation screws 4.2x14 through the pre-drilled holes in the
shaft profiles bottoms.
For glass panels see chapter 6.7 GLASS PANELS .
When the first wall is almost ready and the top wall panel needs to be cut it is important that you meas-
ure and cut the right part of the panel as there are different profiles in top and bottom. The cut part of
the wall panel then can be reused as a “start” panel over a door, see Fig. 59
Mounting of Filled wall
panels
7000 100 en-GB AD
65